Table of Contents
Advertisement
Call-in/call-out setup menu
Note: The information in this section regarding the configuring of serial ports, and modems attached to
those serial ports, applies only to the serial port S2 on the CEC backplane (location U0.1-P1).
These serial ports are typically used for call-in and call-out.
CALL-IN/CALL-OUT SETUP MENU
1. Modem Configuration Menu
2. Serial Port Selection Menu
3. Serial Port Speed Setup Menu
4. Telephone Number Setup Menu
5. Call-Out Policy Setup Menu
6. Customer Account Setup Menu
7. Call-Out Test
NOT supported in LPAR mode
98. Return to Previous Menu
99. Exit from Menus
0>
v Modem Configuration Menu, see "Modem configuration menu" on page 277.
v Serial Port Selection Menu, see "Serial port selection menu" on page 277.
v Serial Port Speed Setup Menu, see "Serial port speed setup menu" on page 278.
v Telephone Number Setup Menu, see "Telephone number setup menu" on page 278.
v Call-Out Policy Setup Menu, see "Call-out policy setup menu" on page 279.
v Customer Account Setup Menu, see "Customer account setup menu" on page 280.
v Call-Out Test tests the configuration after the modem is installed and configured correctly.
276
NAS Gateway 500 Service Guide
Advertisement
Table of Contents
