Installation Location; Installing The Indoor Unit - Mitsubishi Electric Mr.Slim PSA-RP·KA Installation Manual

2. Installation location

C
*
B
Fig. 2-1

3. Installing the indoor unit

1
3
5
7
Fig. 3-1
A
1
B
C
D
E
Fig. 3-2
D
W
B
2
4
6
2
2.1. Outline dimensions (Indoor unit) (Fig. 2-1)
Select a proper position allowing the following clearances for installation and main-
tenance.
Models W
71,100,125,140 600
* Do not place any objects within 1000 mm of the air outlet.
Warning:
Mount the indoor unit on a ceiling strong enough to withstand the weight of
the unit.
3.1. Check the indoor unit accessories
The indoor unit is supplied with the following spare parts and accessories.
Part number Accessory name
1
Tip-over prevention bracket
2
Tapping screws (with washer)
3
Gas pipe insulation (large)
4
Liquid pipe insulation (small)
5
Band
6
Drain socket
7
Bushing (for the wire hole)
3.2. Tip-over prevention bracket (Fig. 3-2)
1
To prevent the unit from tipping over attach the tip-over prevention bracket to the
wall.
F
1 Tip-over prevention bracket
A Tapping screws 4 × 10 (with washer)
B The long edge of the unit
C The short edge of the unit
The tip-over prevention bracket 1 is set on the top surface of the unit. Remove the
tapping screws 2, and then reinstall the bracket, as shown in the illustration. For the
proper installation distances, see Fig. 3-3.
D Screw
E Remove the screw D and then pull the grill forward to remove it.
G
Example of a tip-over prevention bracket
If the wall or floor is made of a material other than wood, use a suitable device such
as a commercially available concrete anchor to hold the unit in place.
2 4 × 25 tapping screws
F Hold the bracket in place with the tapping screws 2.
G The bottom of the unit can be held in place by four anchor bolts which can be obtained lo-
cally.
D H
360 1900 300 Min. 100 Min. 1000 Min. 5
Q'ty
The top surface of
1
the unit.
3
1
1 Inside the air intake
grill.
5
1
2
(mm)
Setting location
3