Connect The Switch To A Power Source - HP ProCurve 2224 Installation Manual

2.
Horizontal Surface Mounting
Attach the rubber feet included in the accessory kit to the bottom of the
switch, then place the switch on a table or other horizontal surface. Use a
sturdy surface in an uncluttered area. You may want to secure the networking
cables and switch power cord to the table legs or other part of the surface
structure to help prevent people from tripping over the cords.
N o t e
Make sure the air flow is not restricted around the sides and back of the switch.

5. Connect the Switch to a Power Source

1.
2.
Attach the switch to the wall or wood surface with 5/8-inch number 12
wood screws (not included).
5/8-inch
wood screw
Plug the included power cord into the switch's power connector and into
a nearby AC power source.
Re-check the LEDs during self test. See "LED Behavior" on page 2-7.
Installing the Switch 2224
Installation Procedures
2-11