Removal Of Dvd Deck Parts; Disc Removal Method At No Power Supply - Toshiba MD14F51 Service Manual

2. REMOVAL OF DVD DECK PARTS

NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the disassembly
is done. If the repair is needed except listed parts, replace
the DVD MECHA ASS'Y.
2-1: TRAY (Refer to Fig. 2-1-A)
1. Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
Unlock the 2 supports 1 and remove the Tray.
2.
1
Tray
NOTE
1. In case of the Tray installation, install them as the circled
section of Fig. 2-1-B so that the each markers are met.
Loader Ass'y
2-2: TRAVERSE ASS'Y (Refer to Fig. 2-2-A)
Remove the screw 1.
1.
Unlock the 2 supports 2.
2.
3. Remove the Insulator (R) from the Loader Sub Ass'y.
4. Remove the Traverse Ass'y.
DISASSEMBLY INSTRUCTIONS
Loader Ass'y
1
Fig. 2-1-A
Tray
Fig. 2-1-B
Loader Sub Ass'y
Traverse Ass'y
• Screw Torque: 2.0 ± 0.5kgf•cm
NOTE
In case of the Traverse Ass'y, install it from (1) to (4) in
1.
order. (Refer to Fig. 2-2-B)
2. In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 2-2-C.
Loader Ass'y (Bottom Side)
(3)
(2)
(4)
B2-1
1
2
2
Insulator (R)
(3)
Rack Loading
(3)
Holder Traverse
(1)
Traverse Ass'y
(4)
Check Lock
Loader Ass'y
Check Hook
Fig. 2-2-A
Fig. 2-2-B
Fig. 2-2-C