Panasonic Viera TH-P42ST30Z Operating Instructions Manual page 30

Available range for the 3D Eyewear
If the 3D Eyewear is placed outside the available area for about 5 minutes, the 3D Eyewear will be
turned off automatically.
: Available area to use the 3D Eyewear
Approx.
3.2 m
View from the top
Note
•
The range may be shortened depending on the obstacles between the infrared sensors on the TV and
the 3D Eyewear, the dirt of the infrared sensors or the surrounding environment.
•
If you do not look toward the TV screen for a while when viewing 3D images, the 3D Eyewear may be
turned off automatically even if in the available area.
To view the 3D images
You can watch 3D images in the following cases:
•
When a 3D image supporting Blu-ray Disc is played on a 3D image supporting player/recorder
connected using a HDMI cable to a 3D image supporting television.
•
3D image supported broadcast (programme)
•
3D Photo, 3D Movie taken by LUMIX/Camcorder.
•
2D→3D (Converts 2D images into 3D)
To view the contents or programmes
1 Set the power switch to "ON".
(The indicator lamp will light for approximately 2 seconds, then flash once approximately every
2 seconds.)
2 Put on the 3D Eyewear
3 Watch the 3D images
When the HDMI receives information in which 3D mode is detected, 3D images are automatically
displayed according to the signal.
If the 3D images are not displayed correctly or the images cause discomfort, the images can be
adjusted by [3D Mode Selection] or [3D Settings].
•
Change the view 3D ↔ 2D, 3D settings (p. 31, 32)
■
After Use
1 Set the 3D Eyewear power switch to "OFF".
(The 3D Eyewear indicator lamp turns off, and the power turns off.)
2 After using the 3D Eyewear, store it in the case provided.
30
Approx.
35° 35°
3.2 m
"Change the view 3D ↔ 2D" (p. 31)
Approx.
3.2 m
Approx.
3.2 m
20°
20°
View from the side