P Riority S Can; P Riority -C Hannel S Elect; S Can R Evert - Kenwood TK-5220 Instruction Manual

p S
riority cAn
Note: To use Priority Scan, a Priority channel must be programmed.
When using a single Priority channel, the transceiver will
automatically change to the Priority channel when a call is
received on that channel, even if a call is being received on a
normal channel.
When using dual Priority channels, Priority channel  is given
precedence over Priority channel 2. So, if a call is received on
Priority channel  while a call is already on Priority channel 2,
the transceiver will change to Priority channel .
p -c
riority hAnnel
If the Priority channel has been set as Operator Selectable by
your dealer, you can reprogram the Priority channels.
1 Select your desired zone and channel.
2 Press the key programmed as Priority-channel Select.
3 Press
"PRIORITY 2" (
4 Press
S r
cAn evert
The Scan Revert channel is the channel selected when you
press the PTT switch to transmit during scan. Your dealer can
program one of the following types of Scan Revert channels:
• Selected: The last channel selected before scan.
Selected + Talkback: Same as "Selected", plus you can
•
respond to calls on the channel at which scan is paused.
Priority 1/ Priority 2: The Priority channel (either Priority 
•
or Priority 2).
Priority 1 + Talkback/ Priority2 + Talkback: Same as
•
"Priority / Priority 2", plus you can respond to calls on the
channel at which scan is paused.
• Last Called + Selected: Same as "Selected + Talkback",
plus you can respond on the last channel on which you
receive a call after scan has resumed.

S
elect
/ to select "NORMAL", "PRIORITY " (
), or "PRIORITY &2" (
to save the setting and exit.
),
).