R Eceiving - Kenwood TK-5220 Instruction Manual

■ Making Individual Calls (P25)
If a key has been programmed with Individual, you can
make calls to specific persons.
1 Press the key programmed as Individual.
2 Press
• On keypad models, you can enter a unit ID directly.
3 Press and hold the PTT switch to make the call.
• Speak into the transceiver as you would during a normal
transmission.
r
eceiving
Select the desired zone and channel. If signaling has been
programmed on the selected channel, you will hear a call only
if the received signal matches your transceiver settings.
Note: Signaling allows your transceiver to code your calls. This will
prevent you from listening to unwanted calls. Refer to "S
on page 23 for details.
■ Receiving Group Calls (P25)
When you receive a group call with a group ID that matches
the ID set up on your transceiver, and the Network Access
Code also matches, you can hear the caller's voice.
■ Receiving Individual Calls (P25)
When you receive an individual call, a ringing tone will
sound. If the Network Access Code matches and the
squelch type is set to Selective Call, the caller's ID will also
appear on the display.
To respond to the call, press and hold the PTT switch and
speak into the transceiver as you would during a normal
transmission.
/ to select a unit ID.
"
ignaling