Removing Operation Panel; Installing Operation Panel - Kenwood KDV-412 Instruction Manual

Removing operation panel

Removes the operation panel.
1
Open the operation panel
2
Remove the operation panel
Antitheft warning lamp
• Removing the panel turns off the power.
• Since the panel is a precision component, it may be
damaged by shock when exposed to vibration or
dropped. Store the panel with care after removing it.
• Do not store the removed panel in the following places.
- Places exposed to direct sun light
- Places with high humidity
- Dusty places
• This unit is provided with a DSI (Security indicator)
function. If the "DSI" feature is set to "ON" in the <Menu
setup> (page 48), a warning lamp blinks when the panel
is removed for antitheft purposes.

Installing operation panel

Installs the operation panel.
1
Align the operation panel with the main
unit
Push in the panel aligning the hole in the panel
with the shaft at the right of the main unit.
2
Install the operation panel
Push the left side of the panel into the main
unit until it locks.
The panel is now installed and the unit is ready
for use.
English 47