Troubleshooting; Disposal - Ryobi EasyEdge RLT5030SG Operator's Manual

Line will not advance
when you restart the
machine.
Cutting head is hard to
turn.
Grass wraps around the
out put shaft and the
trimmer head assembly.
Line trimmer stops and will
not start again
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
ENGLISH

TROUBLESHOOTING

1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
Grass wrapped or built up
around head.
Cutting tall grass at ground
level.
1) Unit failed
2) Plug is damaged.

DISPOSAL

1. Lubricate with a silicone spray.
2. Install more line (Refer to "Replacing the Cutting
Line" earlier in this manual).
3. Pull lines while pressing release button (item 17).
4. Remove line from spool and rewind (Refer to
"Replacing the Cutting Line" earlier in this manual).
Clean affected parts of the machine.
Cut tall grass from the top down.
1) Contact dealer to check damage
2) Check the plug
7