Generator Assembly And Mounting - DUROMAX XP6500E Owner's Manualanual

Engine runs but
there is no
electrical output
Generator runs
but does not
support all
electrical devices
connected.

GENERATOR ASSEMBLY AND MOUNTING

Generator is supplied with a wheel kit. If you want to install the wheel kit on your unit, please
follow the instructions below. If you will not be using the wheel kit, skip this section.
1. Place the bottom of the generator cradle on a flat, even surface. Temporarily place
unit on blocks to ease assembly.
2. Secure the support leg to the cradle with cap screws (M8 x 16) and lock nuts (M8)
(see figure 22 ).
3. Secure the axle to the cradle with cap screws (M8 x 16) and lock nuts (M8) (see figure
23).
4. Slide a wheel over the axle, then secure the wheel with a retaining pin.
(see figure 24,Figure 25, Figure 26).
5. Position the handles on the cradle and attach, cap screws (M8 x 16) and lock nuts (M8)
( Figure 27,Figure 28).
6. Check that all fasteners are tight.
Figure 22
22
Generator is not on level
surface.
Oil is low
Circuit breaker is off.
Bad connecting wires/cables.
Bad electrical
connected to generator.
Generator is overloaded
Short in one of the connected
devices.
Air cleaner is dirty.
Move generator to a level surface to
prevent low
triggering.
Add or replace oil.
Set the circuit breaker to the "on"
position.
If you are using an extension cord,
try a different one.
device
Try connecting a different device.
Try connecting fewer electrical loads
to the generator.
Try disconnecting any faulty or
short-circuited electrical loads.
Clean or replace air cleaner.
Figure 23
oil shutdown from
Figure 24