Antennas; Watchingtv - Sharp Aquos LC-57D90U Operation Manual

Watching TV
When you turn on the TV for the first time, it will automatically memorize the broadcasting channels where you
live. Perform the following steps before you press TV POWER on the remote control unit.
1. Insert the batteries into the remote control unit. (See page 7.)
2. Connect the antenna cable to the TV. (See page 14.)
3. Plug in the AC cord to the AC outlet. (See page 6.)
Mode 1: Starting TV is quick from standby.
Mode 2: Power consumption is small at the standby.
Channel search
Channel auto search makes the TV look for
all channels viewable in the set area.
Press .....
/~
to select "Yes" for ANALOG, then press
T
to move down.
Press .....
/~
to select "Yes" for DIGITAL (Air), then press
T
to move down.
Press .....
/~
to select "Yes" for DIGITAL (Cable), and
press
T
to move down.
Select "Search Start", and then press ENTER.
• This operation makes the TV search for both ANALOG,
DIGITAL (Air) and DIGITAL (Cable) channels.
Language setting
Select from among 3 languages: English,
French and Spanish.
Press
./T
to select the desired language
listed on the screen, and then press ENTER.
Standby Mode setting
Select the standby setting. (See page 25.)
• When the CableCARD security module is inserted, power
Example
consumption will be higher.
Antenna setting
Make sure what kind of connection is made with
your TV.
Press .....
/~
to select "Air" or "Cable" for ANALOG, then
press
T
to move down.
Press .....
/~
to select "Standard", "HRC" or "IRC" for
DIGITAL (Cable).
Press ENTER to enter the setting.
• There are 3 kinds of CATV system, including Standard,
HRC and IRC. Select the one that matches to your TV.
jll91!l)
• DIGITAL (Cable) setting cannot be selected when a proper
CableCARD security module is inserted.
•
•
•
• Make sure what kind of connection is made with your TV.
• If no channel is found, confirm the type of connection
made with your TV and try EZ setup again. (See page
22.)
@-16