Graphic Part Display Switching; Wallpaper Selecting - Kenwood KDC-W7534U Instruction Manual

• Under the display type other than "Display Type D",
the function item is not displayed. When you select
the display type other than "Display Type D", press [1]
to [6] buttons or [NEXT] button. The function item will
be displayed approximately for 5 seconds.
• The indicator is displayed when the display type is set
to "Display Type C" or "Display Type D".
• To change the information by the Display Type, refer
to the page on the following table for the methods to
alternate by the Display Type.
Display Type
Graphic 1
Text 2
Upper 4
Middle 5
Lower 6
Display Type A/ Display Type B

Graphic part Display Switching

Changing the graphic Display.
1
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [2] button.
Refer to <Notes on Multi-function Key System>
(page 11).
2
Enter display control mode
Press the [2] ("DISP") button.
3
Select the display mode
Press the [1] ("MODE") button.
4
Select the display Type
Push the Control knob towards [4] or
[¢].
Select the "Display Type A"/ "Display Type B"
display.
5
Select the graphic display
Press the [3] ("Graph") button.
6
Select the graphic part display
Push the Control knob towards [4] or
[¢].
Each time you push the knob, the graphic display
alternates between the displays shown in the
table below.
A B C D
17 17 — —
— — —
18
— — 19 19
— — —
20
— —
20 20
Graphic display
Movie 1
Movie 2
Wallpaper
7
Exit display control mode
Press the [6] ("RTN") button.
• The setting of this function is available while "Display
Type A"/ "Display Type B" is selected for the Display
mode.
Display Type A/ Display Type B

Wallpaper selecting

Selecting a wallpaper to display when Display
Type is set to "Display Type A"/ "Display Type B".
1
Select the wallpaper display
Refer to <Graphic part Display Switching> (page
17).
2
Select the wallpaper
Display the wallpapers one after another
Press the Control knob.
Each time you press the knob, the Wallpaper
scan is turned ON and OFF.
When scan is ON, "SCAN" is displayed.
When scan is ON, each wallpaper is displayed
every several seconds.
Select wallpaper manually
1 Turn the wallpaper scan OFF.
Press the Control knob.
Each time you press the knob, the Wallpaper
scan is turned ON and OFF.
2 Select the wallpaper.
Push the Control knob towards [FM] or [AM].
Each time you push the knob, the Wallpaper
changes.
3
Exit Display Control mode
Press the [6] ("RTN") button.
17
|
English