Pba - Sony Ericsson D750i Working Instructions

D750i, K758c, W800 and W700 Working Instructions - Mechanical

3.7 PBA

REMOVAL
Follow the Removal instructions of section 3.1 – 3.6
Be careful not to damage the camera flexfilm and the
board-to-board connector with the tweezers!
Disconnect the camera flexfilm board-to-board connector
by lifting upwards with the flexfilm assembly tool.
Be careful not to damage the camera flexfilm and the
board-to-board connector with the tweezers!
Disconnect the camera flexfilm board-to-board connector
by lifting upwards with the flexfilm assembly tool.
Use the front opening tool to separate the PBA from the
frame.
Two frame snap fit hooks, located in the middle section,
are to be released.
Place the opening tool between the PBA and the frame
and turn the tool until the PBA is released.
Place the front opening tool as shown (1).
Do the same thing on the opposite side (2).
Do not bend the PBA too much upwards!
To remove the PBA, lift the top of the PBA up and away
from the frame as high as it takes until it can be easily
moved.
3/00021-1/FEA 209 544/95 G 19(43)
©
Company Internal Sony Ericsson Mobile Communications AB