Connecting Wires To Terminals - Kenwood KDC-W5137Y Instruction Manual

Connecting Wires to Terminals

REMO.CONT
To Kenwood disc changer/
External optional accessory
Fuse (10A)
Wiring harness
(Accessory1)
TEL mute wire (Brown)
Power control/Motor antenna
control wire (Blue/White)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
Steering remote control
(Light Blue/Yellow) (KDC-W5137 only)
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.
Rear left output/Sub Woofer left output (White)
Rear right output/Sub Woofer right output (Red)
If no connections are made, do not
let the wire come out from the tab.
Battery wire (Yellow)
Ignition wire (Red)
See next page
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
FM/AM antenna input
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
Connect to the terminal that is grounded when
MUTE
either the telephone rings or during conversation.
To connect the Kenwood navigation system, consult
your navigation manual.
Connect either to the power control terminal
P.CONT
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.
ANT CONT
To connect these leads, refer to the relevant
instruction manuals.
Antenna Cord (ISO)
|
29
English