General Information; Diagnosis; Id Number And Id Data Setting - Pioneer XV-DV1000 Service Manual

1

7. GENERAL INFORMATION

QQ
3 7 63 1515 0

7.1 DIAGNOSIS

7.1.1 ID NUMBER AND ID DATA SETTING

A
Entering the ID Number and ID Data for Players with DVD-Audio and DVD-RW
Compatibility
It is necessary for a player with DVD-audio and DVD-RW compatibility to set an individual number (ID number) and ID data. If the
number and data are not set correctly with the following procedure, operations in the future may not be guaranteed. You will find the ID
number to be set on the yellow label on the rear panel.
Important: If no yellow label is found on the rear panel, write down the specified ID number by checking it according to "How
to confirm the ID number" shown below.
The Input is Necessary When:
B
• Downloading FLASH-ROM is finished. (The latest version must be downloaded when a repair is made.)
• "No ID Number" is displayed on the screen or OEL display immediately after the power is turned on or in Stop mode.
• If "No ID DATA" is displayed, the ID data must be entered.
Note:
Be sure to enter the ID number in Stop mode.
Use the service remote control (GGF1067) for operations. Only opening/closing of the tray are performed from the player.
Use Disc No. : GGV1084
How to Input the ID Number and ID Data
1 To enter the input mode, press ESC + STEREO in a status with
C
no ID number set, such as after FLASH-ROM downloading.
2 As number input is enabled when the unit enters the input
TE
mode, input the 9-digit ID number. L 13942296513
(The entered number is also displayed on the OEL display.)
[Player's ID Number Setting]
ID Number ?
> - - - - - - - - -
2
<CLEAR> Exit
D
Input ID Number !
3 After inputting the number, press SEARCH to register the ID
number.
[Player's ID Number Setting]
ID Number ?
E
> 0 0 0 0 0 0 0 0 1 OK ?
<PLAY>
<SEARCH> Enter
3
Input ID Number !
www
F
96
1
http://www.xiaoyu163.com
2
Compare Mode
x ao
y
. i
2
http://www.xiaoyu163.com
3
8
4 When the ID number has been registered, the unit enters the
ID data input mode. (The OEL display indicates "NO ID
DATA.")
In this condition, place the ID data disc on the tray and close
the tray using the CLOSE key "7/0" on the player.
Q Q
[Player's ID Data Setting]
3 6 7
<CLEAR> Exit
Insert The ID Data Disc !
4
5 While the data are being read, the message shown in the
figure at left is displayed on the screen.
(The OEL display indicates "RD ID DATA.")
[Player's ID Data Setting]
Loading The ID Data Disc !
5
u163
XV-DV1000
3
4
2 9 9 4
1 3 1 5 0 5 8 2 9
m
co
.
4
2 8
9 9
9 4 2 8 9 9