Connecting Wires To Terminals - Kenwood KDC-228 Instruction Manual

Connecting Wires to Terminals

KDC-MP2028
A Front left output (White)/
Front right output (Red)
B To KENWOOD disc
changer/ External
optional accessory
To connect these leads, refer to the
relevant instruction manuals.
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal
of the motor antenna, or to the power
terminal for the booster amplifier of the
film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To connect the KENWOOD
navigation system, consult your
navigation manual.
To front right speaker
Ignition key switch
Car fuse box
(Main fuse)
Battery
+
KDC-MP228/228
—
To KENWOOD disc
changer/ External
optional accessory
Fuse (10A)
White/Black
To front left speaker
White
Gray/Black
Gray
Green/Black
To rear left speaker
Green
Purple/Black
To rear right speaker
Purple
Car fuse box
–
Rear left output (White)/
Rear right output (Red)
B
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
ACC
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)
English
A
25
|