Table of Contents
Advertisement
The MR Drivers installation
1. Clicking the Stop button causes loud pops while playing Midi through
Media Player, when Headphone control is used.
2. Playing any wave using the Dsound application causes a loud pop
when the Play button is clicked.
3. After Remove/Refresh, no software wavetable audio is available after a
reboot.
4. The Play and Stop button cause loud pops while playing wave through
the Media player.
5. There may be some feed back noise when Microphone boost is
enabled.
6. A reboot may be required to play MIDI audio after the initial
installation of the driver.
7. Panning Headphone and Wave balance in the Output mixer while
playing a Wave/CD/Line-in signal causes a pop.
Special Design Considerations
1. The Headphone does not mute the audio when the headphone slider is
adjusted to the minimum value.
2. SW Synth slider jumps to max value, when Synth state is switched from
Stop to Play or viceversa.
3. Master Volume levels are quite low when compared to Headphone
volume levels.
4. Fastforward and Rewind Controls in the Media Player can not enabled.
5. When resuming from sw wavetable playback, midi is paused.
6. Digital CD Audio is recorded by loopback mux selection.
7. Mono Mix volume is low.
8. Some Dos games do not run in a Dos Box. This support is provided by
the Microsoft legacy Audio emulator.
Note: The above limitations list is as provided by the codec manufacturer,
SOYO will provide customers with new driver releases through the SOYO
website as soon as they are released by the manufacturer.
85
SY-7IWM/L
Advertisement
Table of Contents
