Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for AER amp one
Summary of Contents for AER amp one
- Page 1 one...
-
Page 2: Table Of Contents
Page Contents 1. Introduction 2. Safety Instructions 3. Controls and Connections 3.1 Front Side 3.2 Rear Side 4. Starting-up 4.1 Cabling and Switching-on 4.2 Level Adjustment 5. Functional Characteristics 5.1 Mute 5.2 Tone Control Networks 5.2.1 colour 5.2.2 bass boost... -
Page 3: Introduction
Please take a few minutes to read through these instructions. We want you to understand just what the amp one can do and how to set it up so that you can get maximum benefit out of it. -
Page 4: Safety Instructions
2. Safety Instructions The following instructions help to minimize the risk of 7. Never install your device close to devices with strong injury through fire and electric shock. electromagnetic fields such as large mains transfor- mers, electrical motors, neon illumination etc. Do not 1. -
Page 5: Rear Side
Caution: Risk of electric shock. Do not open! No user serviceable parts DO NOT OPEN AT T E N T I O N inside. Refer servicing to quali ed personnel. Made in Germany by AER. RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR IB_AmpOne_1201 3.2 Rear Side... -
Page 6: Starting-Up
An illuminated clip-LED indicates an overload. A short flicker is no danger to AER devices. During operation a short flicker can be accepted, to be on the safe side you should reduce the gain slightly to achieve an opti-... -
Page 7: Functional Characteristics
5.2 Tone Control Networks pendently and over a wide range. As with all AER products, the amp three is fitted with In this way, the parametric equalizer enables you to an excellent basic tone thanks to the selection of com- equalize frequency response errors –... -
Page 8: Compressor
∞ For a compression ratio of „infinite“ to 1 ( ratio sonance or feedback. we no longer talk about compression, but about limi- ting. Die AER compressor switch here offers compressi- on ratios of 1:1 to 5:1. -
Page 9: Rear Side Features
Together with return, send RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR forms an effect loop path. The effect can be switched on or off via a footswitch. P.S.: For questions or suggestions contact us: tachauch@aer-amps.com... -
Page 10: Technical Specifications
+10 dB at 55 Hz Specifications and appearance subject to change without notice. 15 dB at 200…2000 Hz (adjustable) middle Bandwidth (switchable, note 3): wide: 1.6 octaves narrow: 0.6 octaves treble 12 dB at 6 kHz TD20110627 www.aer-amps.com amp one - 2012_01_GB... -
Page 11: Circuit Diagram
7. Circuit Diagram www.aer-amps.com amp one - 2012_01_GB... - Page 12 - 2012_01_GB...