Connecting The Wireless Access Point To The Gateway; Pairing The Wireless Access Point And Receiver - Cisco ISB7105 Product Manual

Connecting the Wireless Access Point to the Gateway

1. Connect the 12 VDC Power Supply plug on
the access point to the wall power outlet.
Use only the power adapter provided with
the product.
2. Connect the power plug to the power
receptacle on the wireless access point.
3. Connect the supplied yellow Ethernet
cable to the yellow port on the back of the
wireless access point.
4. Connect the other end of the RJ-45 Ethernet
cable to an available yellow Ethernet port on
your gateway.
1
POWER
2
WPS
3
PAIRED
4
LINK
VEN501
Reset
1
Ethernet
2
12VDC
3

Pairing the Wireless Access Point and Receiver

1. Press the OK button on the receiver.
2. Press the WPS button on the wireless access point.
12
Power LED
1
Wi-Fi Protected Setup (WPS) button
2
WPS
Wi-Fi/Paired LED
3
Ethernet Link LED
4
Note: This illustration may vary from the actual product.
Restores factory default settings when held for
1 Reset
more than 10 seconds
Connects the wireless access point to a
2 Ethernet
router/gateway
Port
Connects device to the external 12 VDC power
3 Power
supply
Note: This illustration may vary from the actual product.
RJ-45
Cable
Reset
Ethernet
12VDC
To Wall
Power Outlet
Gateway
Ethernet Port
12VDC
Power
Receptacle