Kenwood DDX7039M Instruction Manual page 13

Playing a USB device
When connecting a USB device, playback starts automatically.
Remove the USB device.
Press on the USB control screen to enter the USB suspend mode, and then remove the USB
device. Refer to <USB Device Control> (page 39).
¤
• Removing the USB device before entering the USB suspend mode may result in damaging the data in the USB device.
⁄
• If the USB source is selected when a USB device is not connected, "No Device" is displayed.
• When the playback is stopped and then restarted, the playback will start from the point where it was stopped at the last
time. Even if the USB is removed and connected again, the playback will start from the last stopped point unless the
contents in the USB device is changed.
• Make sure that the USB device is connected firmly.
C
Switches the function screen
The function control screen switches in the following order each time you press the button.
Picture & Easy Control Panel
Source Control Screen
Picture Panel (OFF)
The following buttons are always displayed on the source control screen.
5
C
Switches AV OUT source
Switches the source that is output at the AV OUTPUT
terminal when it is pressed more than 1 second.
6
1 Displays the Source Select screen. (page 47)
1
2 Returns to the Source Control screen.
3 Displays the Audio Control Menu screen. (page 78)
2
4 Displays the SETUP Menu screen. (page 60)
3
5 Adjusts the Volume.
4 6 Clock display
⁄
5
• Touch displayed at bottom right of various screens to return to
the original screen.
Next page 3
English 13