Kenwood DDX7037 Installation Manual page 4

Connection
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
Connect to the vehicle's parking brake detection switch harness
using the supplied relay connector.
For the sake of safety, be sure to connect the parking sensor.
Ground wire (Black) - (To car chassis)
C
Battery wire
(Yellow)
B
Ignition wire (Red)
A
Ignition key
switch
Car fuse
box
(Main fuse)
+
–
+
Battery
4
|
English
Disc Changer etc.(Optional)
IConnection cable (Included in the disc changer)
PRK SW
Parking sensor wire (Green)
To Vehicle's reverse lamp harness
To car light control switch
( 5A )
Connect to the terminal that is grounded when either
ACC
To connect the Kenwood navigation system,
A
B Depending on what antenna you are using,
connect either to the control terminal of the
Car fuse box motor antenna, or to the power terminal for the
C
To "EXT.AMP.CONT. " terminal of the amplifier
If no connections are made, do not let the cable come out from the tab.
TV tuner (Optional)
Reveres sensor wire (Pink)
Dimmer control wire (Orange/White)
Steering remote control input
(Light Blue/Yellow)
To Steering remote
If no connections are made, do not let
the cable come out from the tab.
B
C
the telephone rings or during conversation.
consult your navigation manual.
booster amplifier of the film-type antenna.
When using the optional power amplifier,
connect to its power control terminal.
having the external amp control function.
UNIT MONITOR TO
FM/AM antenna input
Antenna Cord
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Mute wire (Brown) .
Motor antenna control wire
(Blue) .
Power control wire
(Blue/White)
External amplifier control wire
(Pink/Black)
INPUT ANTENNA TV