Garmin StreetPilot III Quick Start Manual page 7

Attaching Mounting Bracket to Base
1. Slide the locking lever, on the mounting base, to the left (unlocked position).
2. Attach the bracket assembly to the mounting base by sliding the disk on the bottom of the bracket
into the base until it clicks into place.
3. Rotate the bracket assembly left or right until the desired angle is achieved. Slide the locking lever to
the right (lock) to secure the bracket assembly to the base.
Adjusting the Mounting Bracket's Viewing Angl
1. Tilt the GPS unit forwards or backwards by pressing and holding down on the adjustment button on
the back side of the bracket assembly. Adjust the unit as desired and release the button.
2. Rotate the entire bracket assembly by sliding the locking lever to the left (unlocked position). Adjust
the angle as desired and move the lever back (right) to the locked position.
Removing the Bracket Assembly from the Bas
1. Slide the locking lever, on the mounting base, to the left (unlocked position).
2. Press the release tab downward and slide the bracket assembly to the right (see fi gure below).
e
e
Quick Start
Vehicle Installation
Unlock to Adjust
Left/Right
(Unlocked) Press
Down to Release
Press Down to
Adjust Tilt
7