Table of Contents
Advertisement
Available languages
Available languages
Operations from Model-A Control Unit
Direct Access Tuning
Entering the channel and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote.
2
Enter the channel
Press the number buttons.
3
Do Channel Search
Press the [4] or [¢] button.
Canceling Direct Access Tuning
Press the [DIRECT] button on the remote.
• If you make no button operation for 10 seconds, the Direct Access
Tuning mode is automatically canceled.
• You can set up to Channel number 223.
• You cannot search for a channel number which is not
broadcasting.
• If you cannot receive any signal in the input Channel due to a bad
condition on radio wave or another problem, "Acquiring Signal"
appears.
(Function of remote)
Operations from Model-B or C Control Unit
When you have the model-B or C control unit categorized by
the <Which is your control unit?> (page 4), follow the operation
instructions given below.
Sirius ID [ESN] display
You must have the Sirius ID number [ESN] for licensing with
Sirius Corp. Check the Sirius ID [ESN] of this unit as follows.
<B models>
1
Select the Sirius Satellite Radio Mode
Press the [SRC] button.
Select the "SIRIUS" display.
2
Check the Sirius ID [ESN] of this unit
Press the [DISP] button repeatedly until ESN mode is
displayed.
<C models>
1
Select the Sirius Satellite Radio Mode
Press the [SRC] button.
Select the "SIRIUS" display.
2
Change the switching display mode to "Display Type A" or
"Display Type B".
For display mode selection, see the <Switching Display
Mode> section of the instruction manual.
3
Press the [S.A] button to enter the display control mode.
4
Check the Sirius ID [ESN] of this unit
4
¢
Press the [
] or [
5
Press the [S.A] button.
Serial & Sirius ID [ESN]
It is especially important to retain the unit serial number and the
electronic Sirius Identification number for service activation and
potential future service changes.
— 8 —
] button to select the "ESN" display.
Hide quick links:
Advertisement
Table of Contents
