Installation (Non-Japanese Cars); Installation (Japanese Cars) - Kenwood KRC-535 Instruction Manual

Installation (non-Japanese cars)

Firewall or metal support
Screw (M4X8)
(commercially
available)
Metal mounting strap
Phillips truss head
(commercially
sheet metal screw
available)
(commercially available)
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (for example, the sound may skip).
To attach this unit, make sure the front of the control panel faces you
and fit it into the mounting sleeve by pressing the four corners of the
hard rubber frame at the same time.
Do not apply strong pressure to other sections than the corners;
otherwise troubles such as the impossibility of opening or closing the
panel may result.
Installation (Japanese-cars)
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
place.
Factory trim bezel
For Toyota Car
After aligning the factory-
installed radio bracket,
tighten the screws.
— 26 —
Accessory6
Factory-installed
J-Car Bracket
Radio Bracket
(follow indications for L/R)
L
Accessory7
J-Car Trim Plate
(place thick part on bottom)
For Nissan Car
After aligning the J-Car
bracket with the factory-
installed radio bracket,
tighten the screws.
Accessory4
8mm
for Toyota car
5mm
Damage to the unit will result from using screws other than those
provided.
A pair of J-Car Brackets (Accessory 6) are not used when fitting
in a Toyota car.
Factory-installed
Radio Bracket
R
Accessory3
8mm
for Nissan car
5mm