Connecting Wires To Terminals - Kenwood KRC-309S Instruction Manual

Connecting Wires to Terminals

If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.
Ignition key
switch
Car fuse box
(Main fuse)
+ –
Battery
2WARNING
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
KENWOOD disc changer control input
NOTE
To connect the Disc changer,
consult your Disc changer manual.
Fuse (10A)
P.CONT
Power control/Motor antenna
control wire (Blue/White)
ANT.
CONT.
ACC
Ignition wire (Red)
Battery wire (Yellow)
Car fuse
box
Ground wire (Black) · (To car chassis)
2CAUTION
When only two speakers are being connected to the
system, connect the connectors either to both the front
output terminals or to both the rear output terminals (do not
mix front and rear). For example, if you connect the +
connector of the left speaker to a front output terminal, do
not connect the - connector to a rear output terminal.
— 18 —
Rear left output (White)
Wiring harness
(Accessory1)
Rear right output (Red)
FRONT • L
FRONT • R
REAR • R
Front left output (White)
(KRC-409 only)
FM/AM antenna input
Front right output (Red)
(KRC-409 only)
White/Black
To front left
speaker
White
Gray/Black
To front right
speaker
Gray
Green/Black
To rear left
speaker
REAR • L
Green
Purple/Black
To rear right
speaker
Purple