Capturing Video From A Video Source; Step 1: Install Hardware - Creative Sound Blaster Audigy 2 ZS User Manual

Capturing Video from a Video Source

Step 1: Install
Hardware
Connect Audigy 2 ZS
Video Editor to the USB
port you used during
installation. If you
connect Audigy 2 ZS
Video Editor to a
different USB port, the
operating system may
indicate a new device
has been detected and
attempt to locate
drivers.
Follow the next few steps to successfully capture video. Your Quick Start guide has
full instructions on how to connect your Audigy 2 ZS Video Editor.
1. Be sure that you have properly connected and turned on your video source
and Audigy 2 ZS Video Editor. See your Quick Start guide.
2. Put your video device into Play, playback or VCR mode. Do not start playing
video at this time.
Capturing Video from a Video Source 2-1