Table of Contents
Advertisement
(7) Component HDTV signal adjustment
Adjustment items
1
Setup
2
MAIN COMP HDTV
CONTRAST
adjustment
2. Factory settings
Adjustment item
1
INDUSTRY INIT
* Then turn off the AC power supply of the AVC system. (Be careful not to use the power switches of the remote control unit
and DISPLAY unit.)
Notes:
1) Perform factory setting as the latest task. Do not turn on the power after factory setting.
2) Turn the AVC ac power off to turn off the system.
Never turn off the power during factory setting.
3) After completion of factory setting, the system will exit from the process adjustment mode automatically. If not so,
HDCP has been set to off. Check HDCP setting.
4) Factory setting results in initializations of all user settings including channel setting.
(Items set in process adjustment mode are not initialized).
Items initialized by factory setting include the following:
∫
User settings (menu)
∫
Channel data (including broadcast frequencies)
∫
Password
∫
Operation time
∫
Auto installation flag
∫
Optimal manufacturer settings
Adjustment conditions
SIGNAL
∫ COMPONENT HDTV
∫ 100% Colour bar
POINT
INPUT1_COMPONENT
Pin (9) of P801
Adjustment conditions
25
Adjustment procedures
1. Input HDTV (1080i) component signal.
2. Select component source.
100% colour bar signal including 100% white, like
split field colour bar
Adjust the "COMP HDTV CONTRAST" at pin (9) of
P801 to have 0.90 ±0.025 Vp-p from the pedestal
level.
Adjustment procedure
It will be an end, if unite cursor with the line of
"INDUSTRY INI", push a "VOL" button, it changes into
"ON", a "ENTER" button is pushed after that and it is
turned "OFF".
CAUTION:Before a setup is completed, please do not
shut off a power supply by any means.
LC-30HV4M
LC-30HV4H
Advertisement
Table of Contents
