Pride Mobility Go-Chair Owner's Manual page 18

I I I . Y O U R G O - C H A I R
XLR OFF-BOARD CHARGER HARNESS CONNECTOR
SEAT PEDESTAL
CONTROLLER CONNECTOR
BATTERY BOX
MANUAL FREEWHEEL LEVERS
CIRCUIT BREAKER
BATTERY BOX CHARGER PORT
REAR SECTION
FRONT SECTION
Figure 6. The Go-Chair Power Base
Electrical Components
The electrical components are located on the power base. The main circuit breaker is located on the front of the battery
box. The controller connector is located on the back of the power base. See figure 6.
Controller Connector: This is where the controller connects to the power base. Each controller uses a different type of
cable. Regardless of which type of controller is used, the cable must be secured to the assembly and not allowed to drag
on the floor.
Battery Box Charger Port: This enables you to charge the batteries either on the unit or when the battery box is removed
from the power base. See VI. "Batteries and Charging."
Main Circuit Breaker: The main circuit breaker is a safety feature built into your Go-Chair. When the batteries and the
motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to the motors and
the electronics. If the circuit trips, allow your Go-Chair to "rest" for approximately one minute. Next, push in the circuit
breaker button, turn on the controller and continue normal operation. If the main circuit breaker continues to trip repeatedly,
contact an authorised Pride Dealer.
18 www.pridemobility.com Go-Chair