IBM InfoColor 70 User Manual page 38

Parameter
IPS/U2.N4
IPS/U2.N6
IPS/I1.N2
IPS/K3.N6
IPS/U1.N2
IPS/U2.N2
ICN/T9.N8
duplex/transfer
ITR/I4AA.N1
ITR/I6AA.N1
ITR/I7AA.N1
fuser
IFX/T3.N2
IFX/T3.N4
IFX/T3.N10
IFX/T3.N12
IFX/T4.N2
IFX/T4.N4
IFX/T3.N6
IFX/T4.N6
IFX/T3.B4
IFX/T1.N12
GEM
32
IBM InfoColor 70 and 3170 Print Media Guide
Description
Amplification constant of the SW-proportional-integrating controller for
U2.
Time constant of the SW-proportional-integrating controller for U2.
Limitation for the control variable I1 applied during start-up of the U1
controller.
Time that K2.N2 is applied during start-up of the web.
Set point for the initial paper charge for the paper conductivity
measurement.
Set point for the desired conductivity of the paper before printing.
Amount of water flowing through the radiator of the PRS cooling unit.
Current applied to the back of the paper, exerting an electrostatic force
onto the toner. This force holds the toner against the paper when
loosening the paper from the drum.
The positive and negative current respectively, applied to the pair of
duplex coronas positioned between two successive stations. They
inversely charge the toner transferred to the paper by the lower printing
stations.
Temperature set point of the web leaving the fuser; when the GEM is
"off"
Temperature set point of the web leaving fuser; when the GEM is "on"
Amplification constant of the SW-proportional-integrating controller for
T3.
Time constant of the SW-proportional-integrating controller for T3.
Constant A of warm-up temperature of fuser elements (= T3 x T4
dependency).
Constant B of warm-up temperature of fuser elements (= T4
dependency).
Constant C of warm-up temperature of fuser elements (= T3
dependency).
Constant D of warm-up temperature of fuser elements (= constant
term).
Factors A to D are the paper-dependent constants in the formula for the
SW calculation of the warm-up temperature of the fuser elements IFX/
T1.
Alarm level that triggers an alarm when the paper temperature IFX/T3
exceeds it.
Temperature set point of the fuser elements during stand-by.