Table of Contents
Advertisement
Form 2: Specifications for Print Media Qualification on the IBM InfoColor 70 Print Engine
Roll Dimensions
Description
Inner Core Diameter
Outer Core Diameter
Maximum Roll Diameter
Typical Roll Diameter
Maximum Roll Weight
Roll Width
Roll Specifications
The paper must be free from splices, tears, dents, holes and other physical defects. The paper
should be flush with the core and must not slide axially over the core.
Paper Weight
60 to 250GSM are specification limits for InfoColor 70 engine.
200GSM and above require GEM unit.
Temperature Resistance
The paper must withstand prolonged (1 hour minimum) heating to 100 ° C and heating to 200 ° C for
5 seconds without physical or chemical degradation. Under these conditions, the paper should not
release any toxic substances.
Demonstrated Paper Properties
The following data must be submitted for each substrate to be tested.
• Weight (grams/m
• Caliper (micron)
• Brightness (ISO%)
• Opacity (%)
• Smoothness (pps/sheffield units)
• Moisture Content (%AH)
A certificate of non-toxicity is required. This must contain the following statement: "The print
medium will not release toxic gasses when heated up to 200 ° C during 5 seconds and during
prolonged heating at 100 ° C."
Note: The above properties can be tested at the Agencies for a fee.
8
IBM InfoColor 70 and 3170 Print Media Guide
Dimension (USA)
6"-0/+.02
7.1"
19.7"
15.75"
88lbs
12.6"
2
)
Dimension (EU)
150mm+/-.5
174mm
500mm
400mm
40kg
320mm
Advertisement
Table of Contents
