Kenwood KDC-303RG Instruction Manual page 19

• This procedure is not to be used to store the disc and track titles
for MDs that you record.
2
Hold down the NAME.S button for two seconds or more.
"NAME SET" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.
3 Press either the 4 or ¢ button to move the cursor to the
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
You can also move the cursor left or right by pressing the
+ –
TRACK or TRACK buttons, respectively, on the remote
control.
+ –
4
Press the DISC or DISC
character.
Characters that can be displayed are as follows.
Alphabet (upper case) : A ~ Z
Numerals and symbols : 0~9 @ " ' ` % & * + - = , . / \ < > [ ]
NOTE
The operation and characters that can be entered may change
as listed below, depending on the unit that is connected.
+ –
Press the DISC or DISC
character. Besides the alphabet (capital letters only) and
numbers, you can choose the following characters: /,
=, <, >, [ and ].
5
Continue steps 3 and 4 until all the characters are chosen for
the name.
NOTE
You can enter up to 8 characters for each name.
6
Press either the NAME.S button on the main unit or the OK
button on the remote control.
The disc name is stored and the disc name preset mode is
cancelled.
If you make no entry in a 10-second period, the name will be
stored with the characters entered so far.
NOTE
button to display the desired
button to display the desired
+ –
,
• The number of discs whose names can be stored will differ
depending on the disc changer that is connected. Please see
your disc changer manual for details.
• Discs are identified by their total length and number of tracks. If
you play another CD that happens to have exactly the same
specifications as another CD whose name is stored, the wrong
name will be displayed for it.
• If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to enter the
changes.
• Pressing the reset button erases the disc nemes stored in this
unit, but does not erase the names stored in a disc changer.
, *,
— 19 —