Power Off Timer; Cd Read Setting; Demonstration Mode Setting - Kenwood KDC-3034A/G Instruction Manual

In Standby mode

Power OFF Timer

Setting the timer to turn this unit's power OFF
automatically when Standby mode continues.
Using this setting can save the vehicle's battery
power.
Display Setting
"OFF – – –" Power OFF Timer function is OFF.
"OFF 20M" Turns the power OFF after 20 minutes.
(Original setting)
"OFF 40M" Turns the power OFF after 40 minutes.
"OFF 60M" Turns the power OFF after 60 minutes.
• Do this setting after setting <Security Code> (page
21).
Function of the KDC-W4534/KDC-W4034A/AY/G/
GY/KDC-W434A/G/KDC-W410A/AY/G/GY/KDC-
W40G/KDC-W434GY
In Standby mode

CD Read Setting

When there is a problem with playing a CD with
special format, this setting plays the CD by force.
Display Setting
"CD READ1" Play CD and Audio file.
"CD READ2" Play CD by force.
• Setting "CD READ2" cannot play Audio file.
Some music CDs may not play even in the "CD
READ2" mode.
Function of the KDC-W4534
In Standby mode

Demonstration mode Setting

Sets the demonstration mode.
1
Select the Demonstration mode
Push the Control knob towards [FM] or [AM].
Select the "DEMO" display.
2
Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display Setting
"DEMO ON" The Demonstration mode function is ON.
"DEMO OFF" Exit Demonstration mode (Normal mode).
25
|
English