Exterior Lamps Off; Reminder; Headlamp High/Low-Beam; Flash-To-Pass - Chevrolet 2013 Express Owner's Manual

Hide thumbs Also See for 2013 Express:
Table of Contents

Advertisement

6-2
Lighting
If the headlamps are turned on
while the vehicle is on, the
headlamps turn off automatically
10 minutes after the ignition is
turned off. If the headlamps are
turned on while the vehicle is off,
the headlamps will continue to stay
on. To prevent the battery from
being drained, turn the control to the
position.
A warning chime sounds if the driver
door is opened while the ignition
switch is off and the headlamps
are on.
To change the headlamps from low
beam to high beam, pull the turn
signal/multifunction lever all the way
toward you. Then release it.

Exterior Lamps Off

Reminder

If a door is open, a reminder chime
sounds when the headlamps or
parking lamps are manually turned
on and the key is out of the ignition.
To turn off the chime, turn the
headlamp switch to
or AUTO and
then back on, or close and re open
the door. In the auto mode, the
headlamps turn off once the ignition
is in LOCK/OFF or may remain on
until the headlamp delay ends,
if enabled in the Driver Information
Center (DIC). See Exit Lighting
under Vehicle Personalization on
page 5 38.
Headlamp High/
Low-Beam Changer

(Headlamp High/Low-Beam

Changer): Pull the turn signal lever
all the way toward you to change
the headlamps from low to high
beam. Then release it.
This instrument cluster light comes
on when the high-beam headlamps
are on.
I n f o r ma t i o n P r o v i d e d b y :

Flash-to-Pass

This feature is used to signal to the
vehicle ahead that you want
to pass.
If the headlamps are off or in the
low beam position, pull the turn
signal lever toward you to
momentarily switch to high beams.
Release the lever to turn the
high-beam headlamps off.

Daytime Running

Lamps (DRL)

DRL can make it easier for others to
see the front of the vehicle during
the day. Fully functional daytime
running lamps are required on all
vehicles first sold in Canada.
The DRL system comes on in
daylight when the following
conditions are met:
The ignition is on.
The exterior lamp control is in
the AUTO position.

Advertisement

Table of Contents
loading

Table of Contents