4
Processor
Remove the Installed Processor
UPGRADING
This computer uses the Intel Pentium
supplied as a module complete with heatsink. At the time of
writing processors rated at 233Mhz and 266Mhz are
available.
To remove the installed processor, follow these steps:
1.
Observe the precautions in 'Before You Begin' (see
page 1 of chapter 2).
2.
Turn off all peripheral devices connected to the
computer.
3.
Turn off the computer and unplug the power cable.
4.
Remove the computer top and access covers.
5.
Remove the motherboard from the computer chassis.
See 'How to Remove the Motherboard' in chapter 2.
◊ This will mean removing any fitted expansion cards
in the motherboard slots.
6.
Place the motherboard on a flat work surface and
remove any components that block access to the
installed processor.
7.
Remove the top bar of the heatsink support from the
base as shown in figure 37.
8.
Press in on the latches (A) to release the top bar.
®
II processor, which is
LS700 HANDBOOK
4/1