Indirect Lighting; Display Illumination Control; Dimmer; Switching Preout - Kenwood DPX701 DPX501 Instruction Manual

In Standby mode

Indirect Lighting

You can illuminate the area around the display
with soft indirect lighting.
Display Setting
"Lighting : ON"/ "LGHT ON" Turns indirect lighting on.
"Lighting : OFF"/ "LGHT OFF" Turns indirect lighting off.

Display Illumination Control

This function turns off the display when you
perform no operation for 5 seconds. This function
is effective when you are driving at night.
Display Setting
"Display : ON"/ Keeps the display on.
"DISP ON"
"Display : OFF"/ Turns off the display when you perform no
"DISP OFF" operation for 5 seconds.
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 48) is set to
OFF.
• When the display is off, pressing any key will turn on
the display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Ejecting the disc
• Turning off the power
• During function control, such as the Menu System, the
display stays on.
In Standby mode

Dimmer

Dimming this unit's display automatically when
the vehicle light switch is turned ON.
Display
"Dimmer : ON"/ "DIM ON"
"Dimmer : OFF"/ "DIM OFF" The display doesn't dim.
Setting
The display dims.
Function of the DPX501
In Standby mode

Switching preout

Alternating the preout between the rear and
subwoofer. (With the subwoofer the sound
outputs without being effected by fader control.)
Display Setting
"SWPRE R" Rear preout.
"SWPRE SW" Subwoofer preout.
In Standby mode

Built-in Amp Setting

Controlling the built-in amplifier.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP : ON"/ "AMP ON" The built-in amplifier activates.
"AMP : OFF"/ "AMP OFF" The built-in amplifier deactivates.
Function of the DPX701
In Standby mode

G-Counter Level set

Calibrating G-Point. Setting the level according to
the kinds of vehicles.
Display Setting
"G-Counter : Level1" Counter is easy to go up.
"G-Counter : Level2"
"G-Counter : Level3" Counter is hard to go up.
• In the case of driving situations calling for few
accelerations, set the G-Point up to "G-Counter :
Level1". In the case of frequent accelerations, set it up
to "G-Counter : Level3".
39
|
English