Controls And Features - Cub Cadet 930 SWE Operator's Manual

Controls and Features

Chute Assembly
Augers
Snow thrower controls and features are described below and
illustrated in Fig. 4-1.
Shift Lever
The shift lever is located in the right side of the
handle panel and is used to determine ground
speed and direction of travel.
Forward
There are six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (R1) is the
slower and two (R2) is the faster.
10
Headlight
Fuel Tank
Fuel Cap
Oil Fill
Drive Control
Shift Lever
Two Way Chute Control™
Wheel Steering Control
Chute Directional Control
Primer
Clean-Out Tool
Choke
Throttle
Skid Shoe
Oil Drain
Figure 4-1
Choke Control
The choke control is found on the rear of the
engine and is activated by rotating the knob
clockwise. Activating the choke control closes
the choke plate on the carburetor and aids in
starting the engine.
Ignition Key
The ignition key is a safety devise. It must be
fully inserted in order for the engine to start.
Remove the ignition key when the snow
thrower is not in use.
IMPORTANT:
Do not turn the ignition key in
an attempt to start the engine. Doing so may
cause it to break.
Auger Control
Engine Controls
Key
Electric Starter
Outlet
Electric Starter Button
4