Rowenta IS6300 Instruction Manual page 16

1800125390 IS6300 US_110X154 11/06/12 16:19 Page10
Do not attempt to lift up or transport the device holding the Roll & Press shade, the
pedal, the water tank handle or the built-in hanger.
lways roll back the Roll & Press shade before transporting the device.
lways make sure the pole is firmly attached to the base unit before lifting up the
device (see assembly instructions).
2 • Cleaning
• Clean the main unit with a damp cloth.
• Clean the Roll & Press system shade with a damp cloth or non abrasive sponge.
Do not use any cleaning products such as soap or detergents.
• lways handwash the delicates steam cap and wait until it is totally dry before using
again.
• To maintain maximum performance, your steamer must be descaled occasionally.
The time between descaling operations depends on the quality of the water and the
frequency with which you use the appliance. The appliance must be descaled at least
once a year or after 50 hours of use.
• To carry out a descaling operation, follow the following steps:
1. Ensure that the appliance has cooled down completely (2 hours minimum).
2. Fill the water tank with fresh water and place it on the main unit
allowing water to fill the boiler.
3. Remove the water tank from the base and empty out the water via the water tank
filling hole by tipping the device over a sink. Limescale and other residues are
thus removed.
4. Repeat step 2 and 3 several times until the scale has been removed.
C UTION: Don't fill the boiler by the steam head holes !
Never immerse the steam head in water !
10
T
T
T
W
t
h
T
l
a
p
T
s
c
T
s
b
T
g
W
f
If
a