Table of Contents
Advertisement
After each use:
1.
Flush the cleaning gun with warm water after each
use.
2.
Place a few drops of lubricating oil at the trigger pin
(see Figure 3).
3.
Put a light coating of grease on the flow valve o-ring
(see Figure 3).
4.
Add two drops of mineral spirts into the barb fitting
to avoid corrosion (see Figure 3).
SYMPTOM
Tool will not siphon
properly
Average SCFM Requirements
Air Inlet
Siphon Hose
Recommended Hose Size
Maximum Working Pressure
USER-MAINTENANCE INSTRUCTIONS
USER-MAINTENANCE INSTRUCTIONS
Always disconnect the tool from the air supply before performing any maintenance.
TROUBLESHOOTING GUIDE
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE(S)
Buildup of solution in siphon tube
Low air pressure
Air hose leaks
Flow control valve shut off
T
OOL
T
OOL
CORRECTIVE ACTION
Flush with warm water.
Adjust compressor regulator to 90 PSI.
Tighten and seal hose fittings with Teflon® tape if
leaks are found.
Adjust flow control valve to desired flow.
SPECIFICA
TIONS
SPECIFICA
TIONS
5.0 SCFM @ 90 PSI
1/4" NPT (male)
4 Feet
3/8"
90 PSI
5 - ENG
Figure 3
Advertisement
Table of Contents
