Advertisement
TYPICAL
Y
Key
Description
Key
Description
A
Air hose
D
In-line Oiler
B
In-line Filter
E
Air Hose
C
Tee Fitting
F
Whip Hose
OPERA
PE A
To begin using the tool:
1.
As a standard prac ice, drain water from the air compressor
tank and air lines prior to use each day (reference your
compressor operators manual for detailed instruc ions).
2.
Install a 1/4" NPT male connector (not included) into the air
inlet port on the tool (see Figure 2). Note: Use Teflon®
Tape on all threaded connections.
3.
Turn on he air compressor and allow it to build up pressure.
Keep hands and body away from
moving parts.
4.
Adjust the air compressor's regulator or the supply line
regulator to 90 PSI.
5
Lubricate the tool (see user-maintenance instructions).
6.
Connect he tool to he air hose quick coupler. NOTE: It is
recommended that a whip hose with a swivel (P012-0079SP - not included) be used to prevent twisting,
kinking, and excessive wear to the air hose (see figure 1 for recommended connections).
7.
Place the side blades on the edge of he top side of the workpiece (see Figure 3). NOTE: Always lubricate the
material that is being cut. Use standard machine oil on steel and mineral
spirits on aluminum.
8.
Squeeze the trigger gently to start the tool. Move he tool forward keeping the
side blades flush with the workpiece surface. Tool speed is increased by
increasing pressure on the trigger. NOTE: Do not force the tool. Too much
pressure can cause the blades to break or bind. Too little pressure will
cause the blade to not cut properly.
This tool is capable of propelling materials such as metal
chips when in use. Always wear ANSI Z87.1 approved
safety goggles when using this tool.
Edges and pieces of the workpiece are sharp. Wear gloves to avoid injury.
9.
When finished cut ing, remove tool from he workpiece while the motor is still running. Release the trigger to
stop the tool.
USER-MAINTENANCE INSTRUCTIONS
S
Replacement of blades
Always disconnect the tool from the air source before changing the blades or lubricating.
Do not operate the tool if the cutting head and blades are not in place and tightened.
1.
Loosen he 3 allen screws (G) on he cutting head (H). Pull the cutting head straight out while turning it back and
for h to release it from the motor (see figure 4).
NOTE: Refer to Figure 5 for steps 2-11.
2.
Remove the front 2 allen screws that hold the blades in place, being careful not
to loose the spacers (B & E) or the nuts (F) that are on the end of the screws.
3.
Remove the 2 side blades (A & D), center blade (C) and spacers (B & E).
4.
Lay out he new blades as shown in Figure 5.
5.
Lubricate and then insert spacer (B) into he center blade (C).
6.
Reassemble the blades into the cut ing head by placing he center blade (C) on
top of side blade (A) then place side blade (D) on top of center blade (C).
C
INST
N T
ALLAT O
LL
TION
Key
Description
Key
G
Quick Coupler
J
Female Connector
H
Male Connector
K
Spray Gun
I
Air Tool
TING INSTRUCTIONS
I S RU
NS
Figure 3
E
NC
I
UC
NS
4 - ENG
Figure 1
Description
Figure 2
Figure 4
Advertisement
