Table of Contents
Advertisement
2.3 Cleaning
!
Warning
Do not spray or use too much liquid when cleaning the unit. Liquid can enter the unit and damage
sensitive electronic components.
Clean the main chassis with a soft cloth dampened with a mild soap and water solution.
2.4 Installing the 4036B
The 4036B is shipped ready for installation into a standard 19" (48.3 cm) rack. Provisions are
included for mounting General Devices slides with part numbers C-300-S-126, -128 and -130.
2.4.1 Required materials for installation
North American or European IEC power cord. One or the other will be supplied with the unit.
Customer supplied double shielded RG223 cables with BNC connectors from source, and to
next devices in system.
Customer supplied shielded LAN cable for network connection (RJ-45).
Rack-mount slide kit from General Devices, C-300-S-126, -128 or -130 (Optional)
Rack mounting screws.
Screwdriver for the rack mount screws, and slide as needed.
2.4.2 Making Connections
2.4.2.1 Input Power
AC INPUT POWER - The input power to the unit is supplied through a detachable 3-prong
power cable. First plug the female end into the male IEC-320 plug on the rear of the unit,
then plug the male end of the cable into a 100V~ to 240V~, 50/60 Hz power source.
Warning
!
Ensure that this power supply cord is connected to a properly grounded mains receptacle to
ensure safety.
Since the unit does not have a AC Mains Power Switch, both the Appliance Inlet Connector
!
and the Plug on the detachable type power supply cord are considered to be suitable
Disconnect Means for disconnecting the unit from the AC Mains Supply. If the rear of the
unit is not accessible after installation in the instrument rack, the User is responsible for the
provision of a suitable external AC Disconnect Means for the unit.
2.4.2.2 Input Signal
Connect the input signal cable to the INPUT BNC connector on the back of the unit.
4036B Operations and Maintenance Manual Rev. E
11
Hide quick links:
Advertisement
Table of Contents
