Connecting A Pillow Speaker; Pillow Speaker Jack Specifications; Pillow Sound Control - Samsung HG22EA470UW Installation Manual

You can connect a pillow speaker to the TV in the hospital using a jumper cable. The speaker functions as a remote control
and speaker.
Pillow Speaker
1. Connect the pillow speaker jumper cable (cable sold separately) from the television's
speaker jack on the wall behind the television.

Pillow Speaker Jack Specifications

y Output jack: RCA type
y Input jumper pin: 1/8" 3-conductor stereo phone pin.
y Signal specifications: Tip-Audio, Ring-Data/Channel change, Sleeve-Common
Tip
How to Use the Pillow Speaker
y Analog type speaker: The pillow speaker has one key.
– Power On: press the key when the TV is in standby mode.
– Channel Up: press the key when the speaker is on.
– Power Off: press and hold the key for more than 3 seconds when the speaker is on.
– An Analog type speaker always works regardless of the Pillow Speaker Type value set in the Hospital mode
setup menu.
y Digital type speaker: The TV supports the Samsung, Philips, or Zenith code.
– This speaker is only compatible with a specified IR code. You can change the code in the Hospital mode setup
menu.
– The TV gives priority to the Samsung remote control over the pillow speaker's wired remote control.
– Option : Channel Menu Display.
Pillow Speaker Type
CZ
CP
CS

Pillow Sound Control

Speaker Selection Menu
Main
External
y Anynet+ function is not supported in hospital models.
Pillow Volume
y Pillow Volume change the setting about gain value of Audio amplifier to Low, Normal and High.
[Hotel-XC]Install Guide-ENG.indd 17

Connecting a Pillow Speaker

Jumper Cable
Ring Sleeve
Pillow Speaker IR Code
Zenith
Pilips
Samsung
TV Rear Panel
PILLOW
OUT
PILLOW OUT
VOL +
1
3
2
VOL -
TV Speaker
Sound
No Sound
Port to the pillow
Pillow Speaker
Sound
Sound
17
English
2012-03-30 1:27:50