Preparing The Cartridge - Breville Brita Instructions For Use Manual

Preparing the BRITA
1. Remove the cartridge from its wrapping (it is normal for
the cartridge to appear moist during storage).
2. Immerse the cartridge in cold tap water and shake gently
to remove any air bubbles. There is no need to pre-soak
this cartridge before use.
3. Lift the complete lid off your Hot Cup and remove the
filter funnel. Insert the cartridge into the filter funnel
and push it firmly into place. When correctly fitted, the
cartridge should remain in place when the funnel is turned
upside-down.
4. Fill the filter funnel with cold tap water up to the MAX
mark and allow it to filter through discarding the water.
Repeat this process, again discarding the water.
5. The BRITA MAXTRA
®
You do not need to keep the filter cartridge immersed in
water. Refit the filter funnel and filter into your Hot Cup.
Replace the lid.
6. Always make sure that you have spare MAXTRA
cartridges to hand. When buying new cartridges look for
the BRITA MAXTRA
®
7. When it is time to replace the BRITA
cartridge after 4 weeks use, simply lift the handle on top
of the cartridge and pull upwards to remove. BRITA
cartridges are 100% recyclable. Visit www.brita.co.uk or
call the BRITA
®
information on participating retailers.
8. Repeat steps 1-5 with a new cartridge.
6
MAXTRA
®
cartridge is now ready for use.
®
logo on the cartridge packaging.
®
Care team on 0844 742 4800 for further
Cartridge
®
®
MAXTRA filter
® ®
®