Preset Positions - Vivotek IP8173H User Manual

Transparent HTTP Tunnel: If you want to use your own RS-485 device, you can use UART
commands to build a Transparent HTTP Tunnel� The UART commands will be sent through HTTP
tunnel established between the RS-485 device and the camera� For detailed application notes,
please refer to URL Commands started on page 126 or
appnote/14_document_1.pdf.

Preset Positions

If you select Pelco D protocol, as the PTZ driver and click the Save button, the Preset Position
button will become available� Click on the Preset Position button to open the configuration
window. A total of 20 preset positions can be configured.
Please follow the steps below to configure preset positions:
1� Adjust the shooting area to the desired position using the buttons on the right side of the window�
2� Enter a name for the preset position, which allows for up to forty characters� Click Add to enable
the settings� The preset positions will be displayed under the Preset Location list on the left-hand
side�
3� To add additional preset positions, please repeat steps 1 and 2�
4� To remove a preset position from the list, select it from the drop-down list and click Remove�
5� The preset positions will also be displayed on the main page� Please refer to the illustration on
the next page�
6� Click Save to enable the settings�
2
4
http://download.vivotek.com/downloadfile/support/
1
Functions are the same as
the Control Panel on the
home page
6
VIVOTEK
User's Manual - 97