Eureka 8860-8899 Series Quick Start Manual

QUICK START GUIDE
What's in the carton
STEP
1 1
Easy assembly
Vacuum body & hose
STEP
2 2
Slide on handle.
Use a Phillips
screwdriver.
Tighten 2 screws.
Wrap cord.
Get ready to vacuum
STEP
3 3
Adjust height for carpet.
If vacuum is hard to push,
raise carpet setting.
Push power switch on, turn
knob to clean and activate
static charge for 10 seconds.
PROBLEM SOLVING
Refer to Owner's Guide.
Important safe guards
Handle &
2 screws
Place crevice tool &
wand into tool caddy.
Plug into outlet and
push switch (I) on. Push
bottom switch for carpets.
Turn to extend. Push firmly
to collapse & turn to lock.
Before returning, call
Eureka Customer Service
HELPLINE
1-800-282-2886
8 a.m. to 7:30 p.m. (CST), Monday - Friday
10 a.m. to 6:30 p.m. (CST), Saturday - Sunday
www.eureka.com
Tool caddy (carrying handle)
& 2 screws
Dusting brush
®
Power Paw
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
Moving parts. Make sure power switch is in OFF (O) position before
plugging in power cord. Assemble the vacuum cleaner before using.
Tighten two screws.
Place hose over
hose hook.
Place dusting brush
behind handle.
Push bottom switch off (O)
for bare floor. Set height
adjustment to bare floor.
For accessories: Loosen
end of wand, pull out
and attach tool.
MAINTENANCE SCHEDULE
Refer to back of dust cup or Owner's Guide.
8860-8899 Series
Available on
some models
Stair hose
Crevice tool & Self-cleaning
extension wand duster
Insert tab & rotate into position.
Secure hose into
hose retainer.
Snap Power Paw
onto handle.
Step on handle release to
lower handle into position.
Lift latch to remove
dust cup. Empty after
each use.
SPECIAL
FEATURE
®