Selecting An Input Signal - Hitachi CP-X880W User Manual

TURNING ON THE POWER (continued)

Selecting an Input Signal

Using the remote control
5
If selecting RGB input
Press the RGB button
Press this button to toggle between the devices
connected to RGB IN 1 and 2. As illustrated
below, each time you press the RGB button, the
projector switches between RGB IN 1 and 2.
Select the signal you wish to project.
• When BNC (RGB) is selected:
RGB
• When BNC (COMPONENT) is selected:
RGB
If selecting video input
Press the VIDEO button
Press this button to toggle between the
devices connected to VIDEO IN, S-VIDEO
IN and COMPONENT VIDEO. As
illustrated below, each time you press the
VIDEO button, the projector switches between
VIDEO IN, S-VIDEO IN and COMPONENT VIDEO.
Select the signal you wish to project.
• When BNC (RGB) is selected:
VIDEO IN
• When BNC (COMPONENT) is selected:
VIDEO IN
Use the ZOOM
6
the screen size
Use the FOCUS
7
the focus
16
Downloaded from www.Manualslib.com
BNC(RGB) DVI
DVI
S-VIDEO IN COMPONENT VIDEO
S-VIDEO IN COMPONENT VIDEO
BNC(COMPONENT)
/
/
manuals search engine
Using the projector's control panel
Turn the INPUT dial
Turning the dial cycles
through the inputs as
shown below. Select the
terminal to which the signal
you want to project is input.
• When BNC (RGB) is selected:
RGB
RGB
COMPONENT VIDEO
• When BNC (COMPONENT) is selected:
RGB
COMPONENT VIDEO
VIDEO
NOTE
Turn the INPUT dial and set it at the
click point, otherwise input signal
selection may be incorrect.
buttons to adjust
buttons to adjust
INPUT
GB
BNC(RGB)
S-VIDEO
BNC(COMPONENT)
S-VIDEO
ZOOM
ZOOM
(Control panel) (Remote control)
FOCUS
FOCUS
(Control panel) (Remote control)
DVI
VIDEO
DVI
VIDEO