How To Use - Remington HC5015 User Manual

Before starting the cut
To attach a comb
To remove the comb
Comb Attachments Hair lenghth
0.5mm length is achieved without any combs.
sTeP 1 – nape of the neck – PiCTURe 1
sTeP 2 – Back of the head – PiCTURe 2
sTeP 3 – side of the head – PiCTURe 3
sTeP 4 – Top of the head – PiCTURe 4
2
090251_REM_IFU_HC240_ INT_ 22L.indd 2
englisH englisH

HOW TO Use

Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
Hold the comb with its teeth upward
Slide it onto and along the clipper blade until the front of the comb firmly sits against the
clipper blade.
Holding the clipper with the blades facing away from you, firmly push the comb upward
and away from the blades.
Each comb attachment is marked accordingly on its outside middle surface (3mm, mm,
9 mm, 12 mm , 18mm , 25 mm
insTRUCTiOns FOR HAiR CUTTing
Use 3mm or 6mm guide comb.
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the
head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
With the 12 mm guide comb attached, cut the hair at the back of the head.
With the 3mm or 6mm guide comb attached, trim sideburns.
9mm or 12mm guide comb and continue to cut to the top of the head.
With the 12 mm , 18 mm guide comb attached, cut hair on top of the head
against the direction in which the hair normally grows.
For longer hair on top, use without a guide comb. Lift the hair on top of the head with a
small hand comb. Cut over the hand comb with the hair lifted or hold the hair between the
fingers to lift it and cut it to the desired length.
Always work from the back of the head.
) .
6
Then change to the longer
15:00:06|05.05.09 Guido Krölls