Table of Contents
Advertisement
NOTE: See PARTS AND FEATURES for
belt #.
Loop the other end of the belt on the belt
pulley on the agitator.
insert the agitator by placing the rounded
portion of the end cap down into the slot in
the nozzle base.
NOTE: It may be necessary to hold the fur-
niture guard out of the way in order to allow
proper insertion of the agitator into the noz-
zle base.
Agilato
Nozzle
End
Base
Base
Cap
Slot
NOTE: Care must be taken due to the
belt tension during reassembly.
Press firmly,
checking to
see that
each end is
completely
inserted.
Check to see that the belt is centered on
the belt pulley.Turn the agitator with your
fingers to see that it turns freely.
To re-attach
Locking
the agitator
@_
cover, insert
the six (6)
tabs into the
six slots
along the
front edge of
Tabs/
the nozzle
Slots
base.
Lower the agitator cover to its original posi-
tion. After positioning the agitator cover,
push forward on the two (2) locking tabs in
order to ensure that they are securely in
place.
Re-fasten Ihe
lurniture
guard retain-
ers to the
posts on both
sides of the
agitator
cover.
Agitator
Cover
Furnltur_
Guard
NOTE: If the agitator cover is not installed
correctly, you may experience a loss of per-
formance and possible agitator vibration,
etc.
Headlight
;ire
Lock Tabs
__Securely
In
Make sure the headlight wires are tucked
securely in place.
Replace the
nozzle cover
and secure
the latches.
Nozzle
_n
Advertisement
Table of Contents
