Solar Tank And Components - Bosch BSS250E-2 Installation And User Manual

SOLAR TANK
Important Note: Please ensure you remove plastic transit plugs from tank and replace with
brass plugs supplied with panel fitting kit (These plastic plugs will not withstand solar water
temperature and will melt causing leakage from tank).
Solar tanks are available in 250 Litre, 300 & 400 Litres capacities. All three tanks have cold
water inlet and hot water outlets on both the left and right hand sides of the tanks for
convenience. The connection points not used must be sealed off with the brass plugs
supplied.
The Solar tanks have incorporated a single element electric solar booster, or the system can
be boosted via a gas booster separate to the solar tank.
The inner tank is manufactured from mild steel sheet coated with a special porcelain enamel.
The tank is protected from corrosion by two magnesium anode rods, which softens the water
and lengthens the service life of inner vessel.
The inner vessel is insulated by a thickened high-density, environment friendly polyurethane
thermal insulation layer.
The external casing is a high quality galvanized sheet shell, with outdoor coating technology,
anticorrosive and rust-resistant, makes for a longer service life.
DIMENSIONS (mm)
Height
Diameter
Material & thickness of
inner vessel
Material and thickness
of shell
Insulation thickness
Minimum inlet Water
Pressure
Maximum inlet Water
Pressure
Connection Cold
Connection Hot
Connection solar
ELECTRICAL
(Not applicable for gas boosting)
Power
amps
Elements
Weight
250 Litre
1325
620
BTC340
R-2.0mm
Galvanised sheet
0.5mm
40mm
200 kPa
750 kPa
20mm
20mm
15mm
240v/50Hz
15
3.6kW
75Kg
15
300 Litre
1545
620
BTC340
R-2.0mm
Galvanised sheet
0.5mm
40mm
200 kPa
750 kPa
20mm
20mm
15mm
240v/50Hz
15
3.6kW
95Kg
400 Litre
1600
710
BTC340
R-2.0mm
Galvanised sheet
0.5mm
40mm
200 kPa
750 kPa
20mm
20mm
15mm
240v/50Hz
15
3.6kW
112Kg