Cadillac 2014 SRX Owner's Manual page 301

10-60 Vehicle Care
16. If the flat tyre was able to
inflate to the recommended
inflation pressure, remove the
maximum speed label from the
sealant canister (5) and place it
in a highly visible location. Do
not exceed the speed on this
label until the damaged tyre is
repaired or replaced.
17. Return the equipment to its
original storage location in the
vehicle.
18. Immediately drive the vehicle
8 km (5 mi) to distribute the
sealant in the tyre.
19. Stop at a safe location and
check the tyre pressure. Refer
to Steps 1 11 under Using the
Tyre Sealant and Compressor
Kit without Sealant to Inflate a
Tyre (Not Punctured).
If the tyre pressure has fallen
more than 68 kPa (10 psi)
below the recommended
inflation pressure, stop driving
the vehicle. The tyre is too
severely damaged and the tyre
sealant cannot seal the tyre.
If the tyre pressure has not
dropped more than 68 kPa
(10 psi) from the recommended
inflation pressure, inflate the
tyre to the recommended
inflation pressure.
20. Wipe off any sealant from the
wheel, tyre and vehicle.
21. Dispose of the used sealant
canister (5) and sealant/air
hose (6) assembly at a local
dealer or in accordance with
local regulations and practices.
22. Replace with a new canister
assembly available from your
dealer.
23. After temporarily sealing the
tyre using the tyre sealant and
compressor kit, take the
vehicle to an authorised dealer
within 161 km (100 mi) of
driving to have the tyre
repaired or replaced.
Using the Tyre Sealant and
Compressor Kit without
Sealant to Inflate a Tyre (Not
Punctured)
To use the air compressor to inflate
a tyre with air only and not sealant: