Darning [] - Kenmore 19501 Owner's Manual

Darning []
F Satin stitch
tOOt
Pressure
dial: "1
Set the Machine
! []
i @GCOl
loeb
\Press
Thread
tension
3_o6
Darmng plate
J
1. Put the darning plate on the needle plate (see p. 36).
2. Stretch the fabric with the hole in the center between
embroidery hoops, as shown.
3. Lower the presser bar and sew at a slow speed.
4. Move the fabric back and forth slowly until you have
covered the darning area.
5. Turn the fabric 1/4 turn and sew another layer of stitching
over the first layer.
NOTE: If your fabric Is thln or badly damaged, use a separate
piece of fabric under the hote to reinforce it.
6. When you finish darning, return the pressure dial to 3 and
remove the darning plate.
M
L
How to darn correctly
Make the turning points of each row blunt
or the stitching wilt draw little holes at the
ends, Beginners may prefer the L or M
movement.
Take care not to get circles.
The quick mastering ot this work depends
on regular guiding.
Therefore:
-- Hotd the hoop correctly,
-- Always work from left to right
(as when writing).
-- Move work lengthways (not sideways)
for selvedge and weftway.
38